Tools and method hub

No long article here. Two things only: the three working tools in one place, and an index that finds the right page by symptom. In a hurry? Read the fourth row of the table below — most "it will not connect" reports have nothing to do with the code.

1. Three interactive tools

2. The five-step launch routine

  1. Settle the network. Decide the SSID and whether staff and guest networks are separate. See staff vs guest networks and SSID naming rules.
  2. Generate a password. Twelve to fourteen characters, excluding look-alikes; never a birthday or a store name in pinyin.
  3. Verify the payload. Run the SSID and password through the validator and confirm byte count, escaping and the encryption field before designing.
  4. Fix the size. Take the calculator's recommendation for your real viewing distance, and keep each module at about 1mm or more (see error correction).
  5. Export and publish. Choose a template in the studio, re-check against the pre-launch checklist, place it in the fixed position, and log the card ID.

3. Find the fix by symptom

SymptomMost likely causePage to read
Camera shows no reactionToo small, inverted, cropped quiet zone, glareTroubleshooting table
iPhone scans, Android does not (or the reverse)Payload format or camera differencesiPhone vs Android
Reports a wrong passwordPayload disagrees with the router, or unescaped charactersPayload validator
Connected but pages will not loadDHCP, captive portal, DNS, guest SSID blocked from WANConnected but no internet
Worked before, fails nowPassword rotated or router replacedOld codes after a rotation
Only reads up closeCode too small, modules under 1mmSize calculator
Prints grey or blurry at the edgesMaterial, glare, ink load, low resolutionPrint sizes and materials
Stopped working after adding a logoToo much coverage or too little correctionLogos and tolerance
Guests keep asking for the passwordNo written hint on the cardGuest WiFi signage
Putting it on a TV, tablet or menu screenBrightness, contrast, resolutionOn-screen display

4. Common questions about these tools

Do these tools upload my WiFi password to a server?
No. All three run entirely in your browser; the SSID, password and results never leave your device, and they keep working offline.
What is the minimum sequence to produce a WiFi QR code?
Five steps: pick the network, generate a password, verify the payload, choose a size, then export and publish. In a hurry you can skip verification and go straight to the studio.
Nothing scans — which page should I read first?
Start with the scan-failure checklist and rule out size, quiet zone, glare and inverted colours; only then come back and verify the payload with the content validator.
Do these tools need an install or an internet connection?
No install is required and they work in a mobile browser. After the first visit the page is cached, so the calculations still work offline.

Tools done — now make the card

The studio supports custom colours, templates and PNG or PDF export, all computed locally in your browser.

Open the WiFi QR code studio

For scenario-based guides — restaurant table cards, rental welcome sheets, office dual networks, events, chains — start from all guides. To check whether the code itself is the problem, start from the three tools above.