How big should the QR code be printed?
Size isn't chosen for looks — it's derived from how far away a guest scans. Enter the real distance below to get the minimum edge, the recommended edge, the 300 dpi pixel size and a carrier suggestion.
Minimum edge (15:1)—
Recommended edge (10:1)—
Pixels @ 300 dpi—
10:1 is the usual safe ratio; 15:1 is the theoretical floor and needs good light and a clean background. For downlights, glass or film, add 20% to the recommendation.
Distance lookup table
| Scan distance | Minimum edge | Recommended edge | Typical carrier |
|---|---|---|---|
| 12 in / 30 cm | 0.8 in / 2 cm | 1.2 in / 3 cm | Business card, small stand |
| 20 in / 50 cm | 1.3 in / 3.3 cm | 2 in / 5 cm | A5 table tent |
| 3 ft / 1 m | 2.6 in / 6.7 cm | 4 in / 10 cm | A4 poster |
| 6 ft / 2 m | 5.2 in / 13 cm | 8 in / 20 cm | A3 stand |
| 10 ft / 3 m | 8 in / 20 cm | 12 in / 30 cm | A2 board |
| 20 ft / 6 m | 16 in / 40 cm | 24 in / 60 cm | Large format, several codes |
Three margin rules
- Measure the farthest distance: a sign at the door gets scanned from three metres, not from arm's length.
- Add 20% for glare: glass, acrylic and gloss laminate eat effective contrast.
- Add 15% with a logo: occlusion reduces readability, and the error-correction level should go up with it.
Right size, still no scan?
Stop enlarging. Check, in order: inverted colours, a trimmed quiet zone, printer scaling, glass or laminate in between. Those four cover most "big enough but won't scan" cases.
Done calculating? Generate it
Set the code size in millimetres in the studio and export 300 dpi PNG / SVG / PDF.
Open the WiFi QR studioRelated guides
Frequently asked questions
What is the smallest a QR code can be printed?
Around 2 cm is the practical floor; below that you need very close focus and good light. Under 1.5 cm most phone cameras struggle, especially on low-fidelity print like business cards.
What ratio should size follow against distance?
The common rule is 10:1 — a 2 m scan wants a code about 20 cm wide. Use 10:1 as the recommendation and 15:1 as the theoretical minimum, then add 20% for glare and low light.
The code is large enough but still won't scan. What then?
Look at contrast and glare: inverted colours, glass reflection, film refraction, washed-out colours. Enlarging further rarely helps; fix the substrate first.
How big should a code be when shown on a phone screen?
At least two thirds of the screen width with brightness at maximum. On-screen scanning succeeds far less often than paper, so print it if you can.