WiFi QR codes at events and trade shows

A café sign is about looking good and sitting in the right place. An event is a different problem: hundreds of devices arriving at once, a ten-minute scan spike at the door, and a network that may have to change mid-day.

1. Size the network first

The code only hands over the password; it cannot make a weak network strong. The usual failure at an event is not a code that won't scan — it's a code that scans and then nothing connects, or drops ten minutes later.

ScaleConcurrent devices (est.)Approach
Up to 50 people, small meetup30–60One commercial router with a guest SSID
100–300 people, conference150–4003–5 access points, one SSID, roaming on
Trade-show booth (your own corner)10–30Bring your own router with a separate SSID
Outdoor / marketVaries4G/5G CPE, and tell guests honestly that speed is limited

Count devices, not people: one attendee with a phone and a laptop is two, and exhibitors bring tablets and hotspots.

2. Placement: spread the scanning

Every sign should spell out the SSID. Events usually have the organiser's network, exhibitor networks and venue WiFi all at once; "scan to join WiFi" alone gets people on the wrong one.

3. Security and throttling, decided beforehand

Four baselines for an event network

  1. Use a dedicated guest VLAN, never the same segment as office or payment systems.
  2. Turn on client isolation so devices cannot see each other.
  3. Cap each device (1–3 Mbps is plenty for messaging and pages) and limit connections per device.
  4. Disable UPnP and port forwarding on the guest network so one compromised device cannot expose the LAN.

Fix the password before printing. Rotating it means the whole room reconnects, and old signs must come down immediately or half the room ends up on a password that no longer works.

4. Fallbacks: prepare three items

BackupWhen it's used
A second code for a backup SSIDPrimary network saturates or hardware fails; swap the sign
A plain text card: SSID + passwordBroken camera, or a locked-down corporate phone that blocks scanning
An electronic copy on your phoneTemporary extra point, or printing that never arrived

Name the backup something unmistakable — "BrandGuest2", not "WiFi2" — and label the sign "use this if the main network is slow."

5. Closing down afterwards

Make the code first

Enter the SSID and password, export PNG, SVG or PDF; A4 and table-tent sizes switch in one click.

Open the WiFi QR studio

Related guides

Frequently asked questions

Is one router enough for an event venue?
Estimate concurrent devices, not head count. A single consumer router typically starts dropping around 20–30 simultaneous clients; beyond that add access points or move to commercial hardware. The QR code itself is unaffected.
Is one sign at the check-in desk enough?
No. Scanning queues form at peak arrival, so put at least one sign at the entrance, the desk, the main hall door and the lounge — that spreads the action across four places.
Can I show the code on a phone screen if printing is late?
As an emergency measure, yes, but glare and screen brightness cause failures on some phones. A printed A5 is more reliable; treat the screen as a supplement.
Will changing the password mid-event disconnect people?
Yes — existing sessions drop at the next reconnect and everyone must re-enter the new password. Settle the password before the event; rotate only if there is real abuse, and pull the old signs immediately.
Should event WiFi be throttled?
Usually yes. Cap each device at 1–3 Mbps plus a per-device connection limit, and disable client-to-client traffic, so everyone can work rather than a few saturating the link.

Templates that fit this setup

Three layouts picked for this scenario — swap the venue name and password, then export.